Total: 1
Lightweight, high-strength structural materials are component enablers in transportation and aerospace, improving carbon footprint and fuel efficiency. Aluminium (Al)-based eutectics have property combinations that qualify them for such applications. However, they are prone to catastrophic failure because of insufficient load transfer across the interfaces between the brittle eutectic phase and the ductile matrix. Here we present a general solution to this problem by engineering these interfaces at the atomic scale, equipping them with excellent load transfer capabilities, thus qualifying such composites for lightweight structural applications. We demonstrate the approach by adding Zr to an Al-Gd-based hypoeutectic alloy, promoting the formation of a coherent Interfacial-Ordered-Phase (IOP) around the brittle Al3Gd eutectic phase and nanosized core-shell ordered precipitates in the primary Al matrix. This enables a 400% increase in tensile plasticity while retaining a high tensile strength of 295 MPa at room temperature and 130 MPa at 250C. This exceptional increase in formability is attributed to the ability of the IOP layer to prevent dislocations from accumulating at the weak fibre/matrix interfaces, avoiding stress concentrations that would otherwise initiate fibre breakage and debonding. The core-shell precipitates in Al cause a large number of dislocation cross/multiple-slips on different {111} planes, forming ultra-fine (10 nm) dislocation networks that leverage substantial plastic strain accumulation. The approach shows how atomic interface design overcomes the ductility limitations of lightweight high-strength ductile eutectic alloys for structural applications.