Total: 1
The Cr$_2$O$_3$ solid target for low-energy $^{16}$O+$^{16}$O fusion experiments was fabricated using filtered cathodic vacuum arc (FCVA) deposition. Its composition, oxygen areal density and impurity content were characterized by elastic backscattering spectrometry (EBS), and the impurity-induced background contributions were investigated by in-beam $γ$-ray spectroscopy. EBS results indicate that the Cr$_2$O$_3$ film exhibits good stoichiometry and uniformity, with $^{16}$O areal densities ranging from $(3.24-3.25)\times10^{17}$ atoms/cm$^2$. The EBS analysis reveals a carbon atomic fraction of approximately 1.25-1.29\% in the Cr$_2$O$_3$ layer, while a large amount of carbon impurities are also identified on the surface of Cr substrate. In-beam $γ$-ray spectra reveal prominent transitions associated with $^{27}$Al and $^{24}$Mg at 844, 1015, and 1369 keV, mainly originating from $^{12}$C+$^{16}$O fusion reactions induced by carbon impurities under $^{16}$O irradiation. Meanwhile, characteristic $γ$-rays emissions from evaporation channels of the $^{16}$O+$^{16}$O reaction, including $^{31}$S, $^{31}$P, and $^{28}$Si, were also observed and can be used to extract the $^{16}$O+$^{16}$O fusion cross sections. This work provides an experimental basis for the development of high-purity oxide targets and the optimization of target configurations for future low-background $^{16}$O+$^{16}$O fusion cross section measurements.